Industrial Painting & Coatings in Baldwin & Mobile Counties, AL
Cyclops Painting & Coatings applies industrial painting and protective coating systems to warehouses, metal buildings, structural steel, tanks and equipment across Baldwin and Mobile Counties, Alabama. Each system is specified for the surface and its exposure, the prep follows SSPC standards, and the work is scheduled around your operation.
Industrial painting isn't commercial painting with bigger walls
Steel, tanks and equipment don't fail the way an office wall does. They corrode, and on the Gulf Coast they corrode fast. Salt air, summer humidity between 60 and 90%, intense UV and frequent rain all work against a coating here. Steel that would last years inland can start rusting within a season if it isn't protected properly. That's why industrial work starts with the right system, not the right color.
What our industrial painting and coatings include
Warehouses and distribution centers
Metal panels, block walls, structural steel and dock areas, coated so the building holds up to traffic, moisture and salt air.
Metal buildings, shops and barns
Recoating of metal siding and framing, including rust remediation before the new system goes on.
Manufacturing and processing facilities
Coatings for production areas, scheduled by zone, shift or shutdown window so the line keeps moving.
Tanks, pipe and equipment
Protective systems for tanks, piping and equipment exposed to corrosion, chemicals and abrasion.
Railings, stairs and platforms
Safety-critical steel recoated to protect it from rust and keep it looking maintained.
Concrete floors, hangars and aircraft
Epoxy floor systems for plants and shops, plus hangar and aviation coating work. See epoxy flooring and our aircraft painting guide.
How an industrial coating project works
- STEP 01
Site assessment
We check the substrate, the existing coating, how much corrosion there is, the exposure and how the facility runs day to day.
- STEP 02
System recommendation
You get a primer, intermediate and topcoat system matched to the conditions, with the service life you can expect from it.
- STEP 03
Surface preparation
Washing, hand and power tool cleaning or abrasive blasting, as the condition requires, referencing SSPC standards. This is where coatings succeed or fail.
- STEP 04
Application and closeout
Coats applied at the film thickness the system calls for, with temperature, humidity and dew point checked. We finish with a walkthrough and a maintenance recommendation.
We keep work areas controlled and coordinate with your safety team. For growing projects in Baldwin County, from logistics parks to new plants, specifying the coating system at the start costs far less than correcting it once the building is in use.
How much do industrial coatings cost?
The cost of an industrial coating project depends mostly on surface condition and prep. A building kept on a 5 to 7 year repaint cycle needs far less work than one where rust has set in, which can mean blast prep, rust remediation, primer and a full system. We quote after a site assessment.
- 01Surface area and type (steel, metal panel, block, concrete)
- 02Existing coating and corrosion level
- 03Prep standard required (hand tool, power tool or blasting)
- 04Coating system and number of coats
- 05Access and scheduling (shifts, shutdowns, heights)
Commercial paint vs. industrial coating system
| Factor | Commercial paint | Industrial coating system |
|---|---|---|
| Purpose | Appearance and standard protection | Protection from corrosion, chemicals and abrasion |
| Typical surfaces | Offices, retail, drywall, stucco | Structural steel, tanks, equipment, concrete |
| Prep | Cleaning, patching, caulk | Hand or power tool cleaning or abrasive blasting to SSPC standards |
| Layers | Primer and finish coats | Primer, intermediate and topcoat at a set film thickness |
| Maintenance | Repaint when it looks worn | Inspection interval and planned touch-ups |
Industrial coatings FAQ
Request an industrial estimate
Call 251-215-4454 or request your free estimate online. We answer Monday to Friday, 8:00 AM to 5:00 PM.